High Volume Rotary Drum Pump with FilterThis is a great manual drum pump and filtering combination. PLEASE NOTE |
|
Specifications
Use: | Diesel fuel, petrol, kerosene and low viscosity oils up to SAE 30 |
Discharge Volume: | 1 litre per rotation / 100 litres per minute |
Inlet/Outlet: | Suction Tube: 32mm ID x 1m | Delivery Hose: 25mm ID x 2.2m long |
Materials: | Cast Aluminium, Buna N Seals |
Operating instructions
1. Oil Gears Before Use
Before using the 5080AN high volume rotary refuelling pump, make sure that you fill the gear cover with oil. Fill with SAE 30 oil or equivalent to the reference line through the lubrication bolt hole (as indicated on the diagram). Inspect periodically.
2. Revolution Direction
The handle turns in a clockwise direction and the pump discharges one litre per one revolution of the handle.
3. Filter
A filter of #60 mesh polyethylene net is supplied as standard on the pump and is located at the bottom of the suction pipe. Rotating the handle and therefore operating the pump may become harder if the filter is clogged with impurities that may have been filtered out of the fuel or low viscosity oil. It is recommended that you remove the filter periodically and clean it with kerosene.
4. Cautions
- Suitable liquids include most low viscosity liquids such as diesel, unleaded petrol, kerosene and low viscosity oils. Although the pump can be used to pump other liquids of high viscosity, the pump becomes harder to operate and doing so will shorten the life of the pump & may void the warranty.
- Do not use this pump for any solvent or chemical transfer as these liquids will dissolve the Buna N seals and gaskets, etc. (Use the 301-A, 401-A, 733 or 933 for solvents).
- Please note when pumping fuels like kerosene, petrol or diesel, these products tend to “dry out” the internals of the pump causing parts “to stick” and the pump not to prime and dispense. To stop this from happening and to increase the working life of your pump, we recommend that you lubricate the gears of the pump by dropping a few drops of oil into the pump body by taking off suction pipe (2000-42) & lubricating at this opening. After undertaking lubrication of the pump in such a manner, please rotate the handle a few times.
- Do not pump liquids containing dirt or particles such as waste oil. Strained liquids may block the filter, preventing discharge, which can damage the pump interior or cause other problems.
Trouble Shouting
Trouble | Remedy |
Handle fails to turn Gears broken | Return for repair. Dirt, etc clogging up the pump - Overhaul & clean. |
Not Priming / Pumping Impeller dry | lubricate at down tube / body point, turn handle a few times. |
Handle is hard to turn Dirt, clogging up the pump |
Overhaul & clean. Filter blocked - Clean the filter |
Handle turns but no dischargeGears brokenShaft or pin broken |
Return for repair |